Table of Contents
Advertisement
18
Attaching the Flat-Panel to the Mount
Mounting bracket adjustments are factory pre-set (see Note).
This section requires two people.
Do not release your flat-panel until you are certain that top and
bottom hooks of both mounting brackets are securely seated
on the upper and lower mounting rails of the wall panel.
1)
Raise the flat-panel past the top and bottom mounting rails on the
wall panel.
2)
Slide the flat-panel down slowly, keeping it close to the wall.
3)
Engage the top and bottom mounting brackets to the rails of the
mount.
19
Locking Safety Screw Installation
Pre-installed
Locking Safety Screw
( 1 per Bracket )
www.planar.com | North America Toll Free: 1-886-475-2627 | Direct: 1-503-748-1100
998-0368-00 - VMT-MXL
The locking safety screws keep the flat-panel from
being accidently dislodged from the VMT-MXL.
1)
Locate the pre-installed security locking safety screw at
the bottom of each of the mounting brackets.
2)
Use the M5 Allen driver (supplied) to tighten the locking
safety screw.
Do not overtighten the locking safety screws.
Note: Tighten screw to surface, then tighten 1/4" turn
ONLY TIGHTEN AFTER
FINAL ADJUSTMENT
Installation Guide
Note: These registers must
align prior to installation.
They are factory set.
Check to determine proper
alignment
Page 9
Advertisement
Table of Contents
