Bosch Performance Line CX System Manual page 91

The motor output requested appears on the display of the
on-board computer (not on Purion). The maximum motor
s
output depends on the selected assistance level.
Assistance Level
"ECO"
"TOUR"
"SPORT"/"eMTB"
l
"TURBO"
1) The assistance factor may vary on the individual versions.
2) Maximum value
Once it is switched on, the eBike system is in the "OFF"
mode.
n
Switching the Walk Assistance On/Off
-
The walk assistance can make it easier for you to push the
y
eBike. The speed of this function depends on the selected
.
gear and can reach a maximum of 3.7 mph. The lower the
selected gear, the lower the speed of the walk assistance
function (at full capacity).
 Using the walk assistance function is only recom-
mended when pushing the eBike. There is risk of injury
if the wheels of the eBike are not in contact with the
ground while using the walk assistance.
To activate the walk assistance function, briefly press but-
ton "WALK" on your on-board computer. After activation,
-
press button "+" within 3 s and keep it pressed. The eBike
drive is switched on.
Note: The walk assistance cannot be activated in the "OFF"
assistance level.
The walk assistance is switched off as soon as one of the
d
following occurs:
– you release the button "+",
– the wheels of the eBike are stopped (e.g. by actuating
t
the brakes or impacting against an obstacle),
– the speed exceeds 3.7 mph.
Note: On some systems the walk assistance function can
be started directly by pressing the "WALK" button.
s Bosch eBike Systems
1)
Assistance Factor
(Derailleur)
Cruise CX
55 % 55 %
120 % 120 %
190 % 210 % ... 300 %
275 % 300 %
Switching bike lights On/Off
On the version which has bike lights powered by the eBike
system, the front and rear lights can be switched on and off
at the same time via the on-board computer.
2)
English–6
0 275 U07 PDC | (9.5.17)
91