JVC DLA-HD2KE Service Manual page 14

3.6 TERMINAL PWB ASS'Y AND MAIN PWB ASS'Y
• Remove the LENS COVER.
• Remove the LAMP UNIT COVER.
• Remove the TOP COVER.
(1) Remove the 6 screws marked J fixing the MAIN PWB
ASS'Y. (Fig.3)
(2) Remove the harness from the connectors
CN711.
(3) Remove the cord wire from the connector
CN505.
(4) Remove the harness from the connectors CN501, CN502,
CN503, CN714, CN707, CN706, CN705, CN713,
and CN708.
3.7 TERMINAL BOARD AND SHIELD SHEET
• Remove the LENS COVER.
• Remove the LAMP UNIT COVER.
• Remove the TOP COVER.
• Remove the MAIN PWB ASS'Y. *1
CN714
CN707
CN706
CN705
CN713
CN704
CN708
CN701
1-14 (No.PA019)
and
CN710
CN504 and
CN704
CN502
CN505
CN711
CN501
CN504
K
(x1)
CN503
(1) Remove the 4 screws marked G fixing the TERMINAL
BOARD. (Fig.3)
(2) Remove the TERMINAL BOARD.
(3) Using a nut driver and the like, remove the 4 screws
marked H fixing the D-SUB connector and DVI connector.
(Fig.3)
(4) Pull out the SHIELD SHEET toward you to remove it.
*1
After (2) in the procedure above, the TERMINAL BOARD and
the SHIELD SHEET can be replaced. However, be careful
about the cord wire and the harness that are not replaced.
3.8 MAIN PWB ASS'Y
• Remove the LENS COVER.
• Remove the LAMP UNIT.
• Remove the TOP COVER.
• Remove the MAIN PWB ASS'Y.
• Remove the TERMINAL BOARD and the SHIELD SHEET.
(1) Remove the 1 screw market K and the 6 screws marked J
fixing the MAIN PWB ASS'Y.
CN710
J
(x6)
MAIN PWB ASS'Y
TERMINAL BOARD
Fig.3
SHIELD SHEET
H
(x4)
G
(x4)