Table of Contents
Advertisement
Operation
4.4 Factory default settings
Parameter
Count mode
Sample volume
Count data
Number of samples
Alarm limit
Alarm size
I/O port
Temperature
Buffer count
Label location
4.5 Configuration setup
4.6 Custom settings
4.6.1 Set the count mode
18
Table 1
provides the default settings for the MET ONE HHPC–6.
Table 1 Default settings
Once the MET ONE HHPC–6 is unpacked and connected to the appropriate intake
device, use the default settings to conduct a 1-minute count cycle. Download the data to
a PC and print the results.
To reset the MET ONE HHPC–6 to the default settings:
1. Hold down the
key and press the
F1
2. Release the
key when the message "Defaulting data" is displayed on the screen.
F1
To perform a 1-minute count cycle:
1. Remove the isokinetic probe cover (black plastic cap).
2. Press the
button to turn on the MET ONE HHPC–6.
POWER
3. Press
(Count) on the Main screen. The count cycle begins and the display above
F1
changes to "RUN". After one minute, the count cycle concludes and the display
F1
above
changes to "COUNT". The results are saved automatically in the print
F1
buffer. Refer to
section 4.7.3 on page 30
the results.
Change the factory-set default settings as needed for a specific application before
sampling. Use the function (
settings as required.
To set the count mode:
1. Press
(Setup) on the Main screen. The Setup Page 1 screen is displayed with the
F2
current Count Mode field selected (refer to
2. Press
(Right arrow) to view the count modes available.
F3
Default setting
Concentration
1.0 L
Cumulative
1
0
1st channel
Printer
°C
0
1
button.
POWER
to transfer the data to a PC and print
to
) and arrow keys on the keypad to customize the
F1
F4
Figure 8 on page
19).
Hide quick links:
Advertisement
Table of Contents
