oticon CIC WL Fusion 2 Quick Installation Manual

oticon CIC WL Fusion 2 Quick Installation Manual

Radio

Advertisement

Oticon Radio Model - Quick Installation Guide

Radio Model Name:

CIC WL Fusion 2
The CIC WL Fusion 2 radio model is a low power, short range, inductive radio transceiver working at 3.84 MHz. It can be seen below:
CIC WL Fusion 2 – Typical Radio Model Assembly
The most important parts of the module are an amplifier (containing a Digital-Signal-Processor (DSP), a radio Front-End (FE), memory and smaller components),
a battery and a coil antenna, all mounted on a plastic faceplate. The microphone is also mounted on the faceplate and externally to it there is normally also an audio
receiver/speaker and some optional push buttons, but they are not part of the radio model. The radio model is intended to be installed in Oticon and affiliated
wireless hearing aid devices of CIC WL (Completely-In-the Canal) and IIC WL (Invisible-In-the Canal) wearing styles.
Oticon A/S
Main +45 39 17 71 00
Kongebakken 9
DK-2765 Smørum
Fax +45 39 27 79 00
Denmark
PEOPLE FIRST
www.oticon.com
CVR-no. 42334219
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CIC WL Fusion 2 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for oticon CIC WL Fusion 2

  • Page 1 The microphone is also mounted on the faceplate and externally to it there is normally also an audio receiver/speaker and some optional push buttons, but they are not part of the radio model. The radio model is intended to be installed in Oticon and affiliated wireless hearing aid devices of CIC WL (Completely-In-the Canal) and IIC WL (Invisible-In-the Canal) wearing styles.
  • Page 2 (PC_DATA and PC_CLOCK) on board CIC WL Fusion 2 – Amplifier Assembly in 2D The module only requires a battery, an external microphone and speaker to be attached in order to run. All components are kept in place by the face plate as mechanical carrier for the radio model.
  • Page 3 Changes or modifications made to this equipment not expressly approved by Oticon A/S may void the FCC authorization to operate this equipment. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.

Table of Contents