Advertisement
Drill a hole in the wall (suitable for thesize
of the wall conduit), then set thefittings
(for example the wall conduit and its
cover).
the pipe allocation to not damage the
open the stop values to the outdoor unit to
ensure the refrigerant pipe connects the
indoor unit with the outdoor unit to create
a smooth flow.
Be sure to use the insulating materials to cover all
Allow the front panel to fall forward to
enable you remove it.
Open the bottom of face plate to a 30 degree
angle.then remove the top of the face plate.
(Refer to Fig.50-8)
The drain pipe of the indoor unit must be heat
Hard PVC binder must be used for the pipe
remember not to put pressure on the side
26
thread.
Advertisement
