Table of Contents
Advertisement
In of the XRT1.1K. A cable can then be run from the
Power Control Out of the XRT1.1K to the In of the
other speaker. (Figure 6
)
Power In
Power Out
Power
IN
OUT
Control
Figure 6– Power Control Connection
Power
Figure 7– Power Control Jack
Control
N/C
Ground
310635SP
(1 of 2)
310637SP
(1 of 2)
310636SP
310637SP
(2 of 2)
Figure 9– Array Packaging
6
The Data and Power Control Cable is McIntosh
part number 170-202. It is a six-foot shielded 3
conductor cable with 1/8 inch stereo mini phone
plugs on each end. This cable will receive an On/Off
signal to illuminate the McIntosh nameplate when
other McIntosh components are turned on.
(Figure 7)
Failure to connect the Power Control Cable will
not affect the sound in any way, but the lighted
nameplate will not glow.
Cleaning and Care
Wood is a natural living material that can be
affected by environmental conditions. It would
be best to keep the Loudspeakers away from heat
sources or windows and avoid exposing them to
Part Numbers for Packing Material
310633SP
310635SP
(2 of 2)
310634SP
Figure 8– Woofer Column Packaging
310640SP
310642SP
310643SP
310638SP
310645SP
(1 of 4)
310646SP
(1 of 2)
310645SP
(3 of 4)
310648SP
direct sunlight.
To clean the wood, use a soft microfiber cloth and
a neutral detergent. Glass cleaner diluted in 50%
water would work. Heavy duty detergents or waxes
may stain the finish and are not recommended.
A soft brush can be used to remove dust.
Take extreme care not to damage any of the
Loudspeakers' delicate membranes.
Packing it Up
The below diagrams show the proper parts needed
to safely rebox the XRT1.1K. To obtain replacement
parts contact McIntosh Customer Service (see
page 3). Make sure all packing material is in good
condition to properly protect the XRT1.1K.
310641SP
310644SP
310645SP
(2 of 4)
310646SP
(2 of 2)
310645SP
(4 of 4)
310648SP
310639SP
Advertisement
Table of Contents
