Indicator Description; Environmental Specifications For Product; Technical Specification; Wiring Diagram - Haiwell PLC User Manual

www.haiwell.com
2.

Indicator Description

PWR: Power indicator. green,constant light -Power normal;not light - Power abnormal.
1
CV / CC / ON: Constant voltage / constant current / PWM indicator, red. Constant on - Corresponding constant voltage /
2
constant current / PWM output; Off - Not output.
LINK: Communication indicator. Divided into four colors according to the severity of the error, from normal to serious: green,
3
yellow flashing, red flashing, red constant-on.
Users need to make corresponding treatment according to the different status of the indicator light, as shown in the following
table:
LINK indicator state
no light
Green constant light
jitter quickly
light-dark flicker
Yellow
darkened and jitter alternately
light-dark flicker
darkened and jitter alternately
Red
constant light
jitter quickly
Note: Jitter: indicator on 30ms and off 30ms； Flicker: indicator on 0.5s and off 0.5s; Alternately: indicator off 0.5s and jitter 0.5s
RJ45 Ethernet indicator: there are two Ethernet LEDs, green and yellow, as shown on the picture:
4
Color
Green light is long bright Physical connection of TCP module and external device is normal;
Green light goes out TCP module fails to connect with external device or the module itself is abnormal
TCP module is connected to an external device normally, and blinking frequency indicates
Yellow light blinks the data transmission speed. When speed is fast, human eye is not easy to distinguish, at
this time, yellow light is long bright.
Yellow light goes out No data transmission communication of TCP module and external device
3.

Environmental Specifications for Product

Item
Temperature/Humidity
Interference immunity
Over voltage resistance
Insulation impedance
Operating environment
4.

Technical Specification

Item
Input voltage range
Output voltage adjustment range
Output current adjustment range
Output Power
Output voltage resolution
Output current resolution
Voltage / current accuracy
Power regulation
Load Regulation
Output ripple
Typical efficiency
Voltage / current display accuracy
Protection type
Heat-dissipating method
5.

Wiring Diagram

Indication information classification
MPU didn't identify the module and no communication
MPU has identified the module but no communication
Serial or parallel port in communication
Without serial or parallel port in communication
With serial or parallel port in communication
Without serial or parallel port in communication
With serial or parallel port in communication
Without serial or parallel port in communication
With serial or parallel port in communication
Operating temperature:0~+55℃ Storage temperature:-25~+70℃ Humidity: 5~95%RH, No condensation
DC EFT:±3000V Surge:±500V
500VAC/1min between DC terminal and PE terminal
Between DC terminal and PE terminal @500VDC,>=5MΩ ,all input/output points to PE terminal @500VDC
Avoid dust, moisture, corrosion, electric shock and external shocks
24V～62V
3V~50V
Single-channel：0~5A double-channel：0~3A
Single-channel：60W double-channel：90W（each 45W）
10mV
5mA
CV：0.5%+5mV CC：0.5%+5mA
CV：0.5%+5mV CC：0.5%+1mA
CV：4%+20mV CC：0.5%+1mA
Max.300mV（Specified output indicator range）
86%（input 65V，output 30V，2A）
CV：1%+5mV CC：1%+2mA
OVP、OCP、OPP（Overvoltage, overcurrent, overload protection）
Heat sink
Haiwell PLC - Programmable Power Module User Manual
Status description
Environment Specification
Parameter
4 / 13
Reference processing mode
Normal
Lack of external power supply
Incomplete firmware
Return to factory maintenance