Table of Contents
Advertisement
Simple Configuration (Single LNB, No Multiswitch)
A simple configuration without a multiswitch might look like the following illustra-
tion. The SIRIUS signal and the satellite TV signal are combined into one and
use the existing satellite TV cable run from the roof all the way into the room in-
side the home where the SIRIUS radio and satellite TV receiver are located. The
signals are then split and connected to each device. The benefit of the SIRIUS
Combiner/Splitter in this scenario is avoiding having to run an additional cable for
the SIRIUS radio from the roof all the way into a room in the interior of the home.
SaTellITe
oUTDooR anTenna
SaTellITe DISH
SaTellITe RaDIo
Adapter
Cable
C
ComBIneR
Common
TV
CaBle RUn
S
SPlITTeR
The next diagram shows the same configuration. Note that in the common cable
run between the Combiner and Splitter there are no devices such a splitter or
DishPro Adapter. If a DishPro adapter is needed, it must be installed after the
Splitter as shown.
Home Signal Distribution Kit Installation Guide
Advertisement
Table of Contents
