Table of Contents
Advertisement
4.
Disconnect the cable from the multiswitch and connect it to the ComBIneD
oUT port on the Combiner (SR2261) as shown. (Refer to page 5 for the
Combiner port identification.)
5.
Using one of the RG-6 cables which you purchased, connect it between the
multiswitch and the DBS In port on the Combiner (SR2261) as shown. (Re-
fer to page 5 for the Combiner port identification.)
6.
Disconnect the existing cable run from the satellite TV receiver/tuner and
connect this end of the cable to the ComBIneD In port on the Splitter
(SR2251) as shown. (Refer to page 5 for the Splitter port identification.)
7.
Connect another of the RG-6 cables you purchased between the satellite
TV receiver/tuner and the DBS TV port on the Splitter (SR2251) as shown.
(Refer to page 5 for the Splitter port identification.)
8.
Connect another of RG-6 cables you purchased between the SIRIUS oUT
port on the Splitter (SR2251) and the f connector end of the supplied RG-
174 Adapter cable as shown. (Refer to page 5 for the Splitter port identifica-
tion.)
9.
Connect the other end of the RG-174 Adapter Cable to the anT connection
on your SIRIUS radio as shown.
10.
Verify that the satellite TV receiver/tuner is plugged into a working AC out-
let. Next, connect the provided AC Power Adapter to the PoWeR In port of
the Splitter (SR2251), and plug it into a working AC outlet.
The installation is now complete.
Home Signal Distribution Kit Installation Guide
M
Multiswitch
Step 6
Combiner
C
Step 8
Splitter
S
Step 10
Step 9
Step 7
Advertisement
Table of Contents
