Installation In A Home Or Office - Sanyo SIRIUS STILETTO 10 User Manual

8. Temporarily plug the cigarette lighter adapter
into the cigarette lighter.
9. Hook the CRSR-10 onto the mounting slot of
the Suction Cup mount. Press and hold the
POWER button to turn the CRSR-10 on.
10. If your Sanyo CRSR-10 has been properly
connected and the antenna is receiving the
SIRIUS signal you will hear audio. If you do not
hear audio, the display will read "Antenna
Error". Reorient the antenna until you hear
audio.
• Make sure the vehicle is not in a garage, or
somewhere the satellite signal could be
blocked.
8
Running the Car Antenna Cable
Before routing the antenna cable, confirm that the
antenna is mounted in a good location.
1. Turn the CRSR-10's power off; unplug the cigarette
lighter adapter from the CRSR-10 and the cigarette
lighter; unplug the antenna from the CRSR-10.
2. Route the cable from the antenna to the vehicle's
interior by tucking it underneath the rubber molding
around windows and under door jams.
3. Route the cable from the lowest point of the rear
window into the trunk. Take advantage of any existing
cable channels or wiring conduits.
• For SUVs, minivans and 5-door vehicles, bring the
cable into the vehicle under the rubber molding for
the tailgate, and continue under the interior trim.
4. From the trunk, route the cable around the passenger
compartment and to the back of the cradle.
• Do not pull the wire across sharp edges that could
damage it. Keep the wire away from areas where it
could become tangled in driver's and passenger's
feet.
5. Plug the antenna into the back of cradle where it says
"ANT".
Sanyo CRSR-10 User Guide
6. Plug the cigarette lighter adapter into 2. Plug the audio cable's mini connector into the back of the
the cigarette lighter. SANYO
RECOMMENDS UNPLUGGING
THE CIGARETTE LIGHTER 3. Plug the AC cord power supply into the back the adaptor.
ADAPTER AFTER YOU TURN THE 4. Plug the antenna into the back of the adaptor until it is firmly
VEHICLE'S IGNITION OFF.
5. Assemble the Home stand and hook the CRSR-10 onto the

Installation in a Home or Office

1. Plug the Adaptor into the bottom of
the CRSR-10.
6. Due to the paths of SIRIUS satellites over the US, the best
1
2
4
3
Sanyo CRSR-10 User Guide
adaptor. Plug the audio cable's white (L ch,) and red (R ch.)
connectors into the aux-in jacks of your audio system.
secure.
home stand as shown below. Tune to your desired channel.
location for the antenna in your home depends on where you
live. Some experimentation may be needed to obtain the best
results. In major US cities, you may also be able to receive the
signal from SIRIUS ground repeaters, which may allow you to
place the antenna away from a window. In all cases, since the
antenna is weatherproof, you can also locate it outside, clear of
any overhead obstructions.
9