Table of Contents
Advertisement
Troubleshooting
PROBABLE CAUSE
FAULT
Blown Fuse, power cable not properly
CRSR-10 does not turn on
connected
Satellite antenna not connected
"Antenna
Not Detected"
Antenna or cable is faulty
message
FM modulator frequency contains static
Audio static or loss of
clarity
Vehicle antenna not connected to radio
No signal on CRSR-10
Check for obstacles over or around
antenna or move antenna placement
display
1. Audio Cables not connected
2. Incorrect FM modulator frequency
No Sound
3. FM transmitter option not turned on
34
REMEDY
Check fuse, check power cable
Check satellite connection to CRSR-10
Contact system installer or vendor
1. Switch to another FM frequency
2. Move CRSR-10 closer to car FM
antenna
3. Use FM switching box
Check vehicle antenna cable
Change location to eliminate nearby
obstacles (bridge, trees, etc.)
1. Check cables at CRSR-10 and radio
2. Select another FM frequency
3. Turn on FM transmitter in CRSR-10
menu
Sanyo CRSR-10 User Guide
Specifications
Audio Output ............................................................................................. 776 mV RMS or 1 v peak to peak)
Total Harmonic Distortion (THD) .......................................................................................................... <0.5%
Signal-to-noise (S/N) ........................................................................................................Greater than 83dB
Fuse Requirement .................................................................................................................... 3A Slow Blow
Power Supply ...............................................................................................7.6V-24V, Negative Ground, DC
Current Requirement............................................................................................................................................1A
Operating Temperature..........................................................................................................................-20 - +70C
CRSR-10 Dimensions ....................................................................... 101mm(W) x 101mm(H) x 32mm(D)
........................................................................................................................... (3.97" W x 3.97" H x 1.26" D)
CRSR-10 Weight ..................................................................................................................................... 240g
Note: Features and Specifications subject to change without notice.
Sanyo CRSR-10 User Guide
35
Advertisement
Table of Contents
