Cleaning Recommendations - Oral-B Genius 9000 Manual

Cleaning recommen-
dations
After brushing, rinse your brush head under
running water with the handle switched on.
Switch off and remove the brush head. Clean
handle and brush head separately; wipe
them dry before reassembling. Unplug the
charging unit before cleaning. Brush head
compartment and protective cover are dish-
washer-safe. Basic charger should be
cleaned with a damp cloth only (picture
Accessories
(depending on model)
Smartphone Holder
• Before each use, make sure mirror, suction
cup surface (11d) and holding brackets
(11a) are always clean and dry (picture
B1). Use a fuzz-free cloth for cleaning
suction cup surface and mirror. In particular
make sure suction cup surface and mirror
are free from any contamination (e.g. hair,
dust, oil, fuzz, dirt etc.).
• Press your smartphone holder (11) just with
enough pressure, centered at nose level
on a sturdy mirror. Then mount the holder
by pressing the lever arm (11b) towards
the mirror until it snaps in (picture B2).
Note: Only affix on mirror to ensure safe
and correct conditions. For use in bath-
room only. Do not use in automobiles.
• Always make sure the smartphone holder
is securely mounted on the mirror before
inserting your smartphone. Place your
smartphone (portrait) sideways in between
the holding brackets (11a) by pressing
against one bracket with your phone and
sliding the other bracket to the side (picture
B2). Follow the same procedure to remove
your phone again.
• Adjust the overall position for the required
angle by moving the ball joint of the holder
(picture B3).
• Once done, remove your phone from the
holder. Take off the smartphone holder by
flipping the lever arm back and pulling the
tab carefully (picture B4 1./2.). Affix
smartphone holder with each use again.
• The smartphone holder should be cleaned
with a damp fuzz-free cloth only (picture
You may use glass cleaner, alcohol or similar
products (avoid products with silicone oil).
10
Make sure the surface is dry and dust free
after cleaning. Store in clean and dry
place. If not in use, always remove your
smartphone from the holder.
Note: Smartphone width required for usage:
minimum 58 mm, maximum 83 mm.
Caution: Small parts may come off, keep
out of reach of children.
Follow your smartphone's user manual to
ensure your phone/charger is designed for
5
).
use in a bathroom environment.
Charging Travel Case
• To charge your handle (5) place it on the
pin in the charging travel case (12) and
connect it to an electric outlet, using the
extra smart plug (13) provided.
• The flashing light (12a) of the charging
travel case indicates that the handle is
charging. Once the handle is fully charged
the light turns off. A full charge can take
up to 12 hours (picture C1).
Note: You may use the USB port (12b) to
charge an electric device while the charg-
ing travel case is plugged in. The handle
can only be charged with the smart plug
(13) (12c) not via USB port.
• The inner lid of the travel case has a
built-in smartphone holder (12d), which
can hold your smartphone while using
(picture C2). Before use, make sure your
phone fits the stand and keeps stable.
• The removable inlay (picture C3) (12e) of
the travel case is dishwasher-safe (picture
5
). The outer case should be cleaned with
a damp cloth only. Make sure that travel
case parts are completely dry before reas-
sembling and toothbrush/brush heads are
dry before storing in the travel case.
Note: Clean stains on travel case surface
immediately. Store travel case in a clean and
dry place.
Follow your smartphone's user manual to
ensure your phone/charger is designed for
use in a bathroom environment.
Beauty Bag
Store your clean and dry toothbrush/brush
heads in the travel case (15) and place it
5 ).
inside the beauty bag (14) (picture D1/2).
Clean stains on the surface immediately. The