Memory Switch Settings - Omron NT20M Operation Manual

Memory Switch Settings

6-3-4 Initialization
Initializing Memory
6-4 Memory Switch Settings
Liquid Crystal Display Type
60
You must initialize the image data memory when using the SRAM or EE-
PROM for the first time. Initialization can also be used to clear all or part of
the data already registered in the PT.
If you select Init. Memory in Maintenance Mode, a screen will be displayed
providing a selection of data to be initialized (i.e., image data, memory table
data, or history data). After one of the choices has been selected, another
screen will be displayed to confirm that you actually want to initialize that
data.
If you select Yes, then initialization will be executed and all of the selected
data will be deleted. (If memory table data is initialized, then the values set
by the Support Tool will be restored.
Memory switch settings set the NT20M display and key input sounds.
Select "Memory SW" from the Maintenance Mode Menu.
MAINTENANCE MODE MENU
Quit
Display History
I/O Check
PT Settings
Initialize Memory
MemorySwitch
Move the cursor to the item that is to be set and press the Enter Key. Each time
that it is pressed, the set value will change.
After the settings have been made, press the Buzzer, Up, and Down keys to re-
turn to RUN Mode. If the power to the NT20M is turned off at this point, the set-
tings will not be registered.
MEMORY SW MENU
Quit
Key Input Sound
Backlight Off
Display
Resume Function
Section 6-4
Select one
ON
10 min
Normal
ON