UPPAbaby Vista 0028P Manual

STROLLER SYSTEM
CAR SEAT ADAPTER
PEG PEREGO PRIMO VIAGGIO

General Safety Information

• Read all instructions before using this
product.
• Periodically check attachment by lifting up
on adapter or car seat.
• Designed to fit all Peg Perego Primo
Viaggio infant car seats manufactured
from the year 2002 until the date of this
purchase.

To attach the adapter

NOTE: Refer to the stroller user guide for
instructions on how to remove the seat from
the stroller.
1) Frame without seat or bassinet (Figure 1).
2) Position the black rubber pads away from the
handle bars (Figure 2). Snap in adapter firmly.

To attach the car seat

3) Snap in car seat firmly.
4) Make sure that all four lock tabs close
around bar.

To remove the car seat

5) Slide up rear lever and lift car seat by handle.

Limited Warranty

Your UPPAbaby product is warranted to be free from any manufacturing defects for a period of 1 year from the date of purchase under nor-
mal use and in compliance with the operating instructions. This warranty extends only to the original retail purchaser and is only valid when
supplied with proof of purchase. Please retain proof of purchase with this Limited Warranty.
Please contact us at 800 760-2060 or service@uppababy.com if you have any questions regarding warranty.
Please note that a problem will not be covered by this warranty if the problem is caused by misuse or poor maintenance.
Model 0028P
WARNING
• To prevent serious injury or death, install and use
according to these instructions.
• Recommended only for infants within the height and
weight limitations of Peg Perego
Primo Viaggio infant car seats.
• Intended for use with UPPAbaby VISTA stroller only.
• Always use infant car seat restraint system as recom-
mended by manufacturer.
• Never leave child unattended.
pads