Table of Contents
Advertisement
Problem
1
Engine cannot be started
2
Engine stops midway
3
Rotor blocked
4
Strange noise
5
Blunt blades
6
Damaged belt
7
Chipped material too coarse
7. Troubleshooting
GBK130 Series Manual Book V1.01
B.W. Machinery
Read the engine users' manual, check the fuel
ON-OFF, see if it's ON, check if gets enough
fuel and engine oil, check the emergency stop
Check if the engine is stopped by overloading,
see if there is any blockage in the chipping
chute. Check the emergency stop button.
Stop the machine, and remove the chute and the
cap of bearing, turn the shaft of roller with a
spanner to clear the blocked material (see
chapter 4.4)
Stop the machine, check if the fastener got
loose, if not, let the professionals to check.
Bring the machine to a servicing centre for
repair/replacement of blades. Or see chapter 5.3
Open the belt cover and change the belt.
(belt can be purchased from us, call
1300454585)
Need to adjust blade anvil. The gap should be
no smaller than 0.5mm and not bigger than
0.95mm. (see chapter 5.3)
Solution
button.
11
Advertisement
Table of Contents
