Table of Contents
Advertisement
2. PREPARE FLOAT CUP (Platinum)
The standard settings for the float cup
are located on the adjuster rod. The
Essential Platinum should be set to 7 ¾".
In many cases the float cup settings are a
measured distance (in inches) from the
bottom of the valve body to the top of
the float cup. Align the very top of the
float cup with the marked line or
measurement on the adjuster rod. After
the cup is set, check the alignment of the
brine valve guide to ensure that it is still
directly aligned over the brine valve body.
Set to one (1).
3. INSTALL BRINE VALVE (Platinum)
Important! When re-installing the brine valve, do not drop the brine valve in the
drum. Dropping will cause the float cup to lower, resulting in an incorrect float
setting. Locate the brine valve in the brine well. Place it so the 3/8" bent tube is
along the back of the brine well away from the brine drum wall. The 3/8" bent
tube is then snapped into the notch and will extend from the brine drum
approximately 1 inch. See Figure 7 for proper location in the brine well.
Figure 6
Figure 7
8
5
4
Platinum Settings
Float Cup
3
Float Cup Height
Adjuster Tube
2
Salt Setting
1
1
7 ¾"
1.25
1.25
Hide quick links:
Advertisement
Table of Contents
