Electrical Connection; Technical Data; Using The Heater - Dimplex DXC20TIE7 Instruction Manual

Contrast convector heaters

Hide thumbs

Table of Contents

Dimensions (millimetres)

Model Specification

DXC20TIE7: 2.0kW convector heater with electronic controls

DXC30TIE7: 3.0kW convector heater with electronic controls

DXC30FTiE7: 3.0kW convector heater with electronic controls and

turbo boost

WARNING: THIS APPLIANCE MUST BE EARTHED

The use of an extension lead or multi-plug adaptor is not adviced when connecting this product to the mains. Connection through these

deviced could lead to risk f overloading, overheating and even fire at the extention lead or adaptor due to inadequate connection quality

This heater must be used on an AC (~) supply only and the voltage marked on the heater must correspond to the supply voltage. This

heater is fitted with a rewirable plug incorporating a a 13 amp fuse. In the event of replacing the fuse in the plug supplied, a 13 amp fuse

approved by ASTA to BS 1362 must be used. If any other type of plug is used, a 15 amp fuse must be fitted in the plug, the adaptor, or at

the distribution board.

IMPORTANT: If the plug is not suitable for your socket, the 13 amp plug should be removed. Before wiring the appropriate plug, please note

that the wires in this mains lead are coloured in accordance with the following code:

GREEN AND YELLOW:

BLUE:

BROWN:

Connect the GREEN AND YELLOW wire to the terminal marked 'E' or by the earth symbol, or coloured GREEN or GREEN AND YELLOW.

Connect the BROWN wire to the terminal marked 'L' or coloured RED. Connect the BLUE wire to the terminal marked 'N' or coloured

BLACK

Model Identifier(s)

Heat output (kW)

Nominal heat output

Minimum heat output (indicative)

Maximum continuous heat output

Auxillary electricity Consumption

At nominal heat ourput

At minimum heat output

In standby mode

Tubo Fan

Contact details

WARNING: DO NOT USE THE HEATER UNTIL THE FEET OR WALL BRACKETS ARE FITTED CORRECTLY

The product can be used as an installed or portable unit. Once the desired application has been decided upon and the requirements below have

been met the product is ready to be used. Simply plug in and switch on at the wall socket.

There are various control options available with various combinations via the membrane buttons and segmented display. Please note - the

element has been coated with a protective film which will burn off during the first few minutes of use and may cause a small amount of fuming.

This is quite normal - the fumes are non-toxic and will quickly disappear. We recommend that you open a window to ventilate the room when

using the heater for the first time.