Sony RM-785 Service Manual page 27

PVM-3230
Next, let's Button 1 on this commander store the "play"
function of manufacturer A's commander.
6
7
While keeping Button 1 on this commander pressed,
press the play button of the manufacturer A's
commander.
When the READY lamp goes out and the LEARN lamp
lights up, release both buttons.
READY
~~1,f,3~
= ---
,....II'....._
Now, A's play function button has been stored on Button
1 of the RM-785.
RM-785
8
After learning is finished, set the LEARN-USE selector
to USE.
I
Notes
I
• When operating equipment with stored functions, the VTR
1 /2/3/MDP selector should be set to the same position as
it was when the functions were stored.
The LEARN-USE selector should be set to USE.
• The functions of other equipment can be stored by
repeating these steps for each of the positions of the VTR
1/2/3MDP selector. Use the supplied index sheets by
placing them on buttons and writing the names of stored
functions for further reference.
• The batteries will last about half a year with normal
operation. Replace the batteries before they wear out.
• Replace the batteries within approximately 30 minutes. If
not, the stored functions may be erased from the buttons.
• Do not use the learning function for equipment other than
audio and video ones.
• Be sure to confirm that the functions have been stored as
a few of the functions of other manufacturer 's
commanders are not storable on RM-785.
• When you have stored a new function on a button, the
previous function is cleared automatically.
LEARN---riE
...,....
The learning function will not work in the following
cases:
• There is a fluorescent lamp or equipment with infrared
rays which emit noise.
-) Move the commanders away from them.
• The batteries are exhausted.
-) Replace all the batteries with new ones.
• There is an obstacle between the commanders , or the
commanders are not positioned head to head and exactly
aligned.
-) Position the commanders properly.
-27-