Gaggia BRERA Operating Instructions Manual page 23

4 Make sure the selector switch is in the
" " position.
5 Press and hold the 2 brew buttons at the
same time for 3 seconds: the descaling
cycle is started.
Note: if the " " and "
indicator lights start blink-
ing immediately after start-up, turn
the selector switch right to the "
position. When the " ", "
" " indicator lights start blinking,
turn the selector switch back to the
" " central position.
6 The " " light blinks to show the
machine has entered the descaling
automatic programme; when the
" " light is steady, the 1 st limescale
removal phase is on.
7 When the " " and " " lights start
blinking, turn the selector switch
clockwise to the " " position; in this
case, the steam/hot water wand starts
dispensing the descaling solution at
regular intervals.
8 The " " light blinks to show the
machine has entered the descaling
automatic programme; when the
st
" " light is steady, the 1 limescale
removal phase is on.
"
"
" and
9 When there is no more descaling solu-
tion left in the water tank, the "
" " and " " lights blink simul-
taneously.
10 Turn the selector switch to the " "
central position.
Empty the container under the steam
wand and the one under the dispensing
spout.
11 The " " light turns on and the water
tank must be removed before entering
the next stage.
12 Remove the water tank, rinse it and
fi ll it up to the "MAX" level with fresh
drinking water.
13 Place the tank back in the machine. The
two " " lights turn on showing the
machine has entered the rinse phase.
The " " and " " lights are blinking
in the display.
14 Place an empty container under the
steam wand and another one under
the dispensing spout.
Turn the selector clockwise to the "
position.
• 23 •
" ,
"