Advertisement
Available languages
Available languages
Step 3– Install the Sensor and Adjust Your Timer
1. Locate and remove the sensor battery compartment cover.
2. Insert three AA alkaline batteries as shown. Install battery
compartment cover (Fig. 4).
Note: The LED signal indicator on top of the sensor will be on for
several minutes to assist in sensor placement.
3. With the sensor at the selected site, verify signal strength,
indicted by the sensor LED color: Green - Excellent,
Yellow - Acceptable, Red (blinking) - Relocate the sensor.
4. Holding the sensor parallel to the ground, push the probes
and stakes straight down through the lawn into the soil until
the sensor is pressed flat against the ground (Fig. 5).
5. At the receiver, press the Bypass
LED will begin blinking and the receiver will display "CA" as it
begins the automatic 24–48-hour calibration operation (Fig. 6).
6. Adjust your sprinkler control timer:
• Set the watering day schedule to water every day of the week
(except watering-restricted days).
• Set the run time duration used during the summer months.
• Run a manual watering operation to water all zones.
This completes basic installation and setup.
information, be sure to download your Precision Soil Sensor
www.toro.com.
User's Guide at:
4
button once. The green
For complete
Fig. 4
LED Signal
Indicator
Fig. 5
Stakes
Probes
Fig. 6
Note: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to part 15
of the FCC Rules. For complete FCC compli-
ance rules, see Precision Soil Sensor User's
Guide, form number 373-0604.
Advertisement
