Genius GM-130024/T Hardware Installation

Energy Mouse 2
Hardware Installation
For Mouse use:
1. Plug the wireless pico receiver to a USB port of a PC.
Make sure the power switch located underneath the mouse is switched to "ON".
2.
For Mouse with power bank function charging:
1. How to start charge Energy Mouse 2
a. Plug the Micro USB cable into the Energy Mouse 2 Micro USB port, and then insert
the other end of the cable into USB port of your power supply (e.g. AC charger, or
computer USB port). The power level LED indicators will be flashing in sequence.
b. When the charge is completed, the four LEDs will stay on for 6 minutes, and then turn
off for power saving.
2. How to charge your mobile device using the Energy Mouse 2
a. Connect your device to the Energy Mouse 2 USB output port and the charging
will start automatically.
b. When your mobile device charge completed or just disconnect the cable; Energy
Mouse 2 will automatically turn off in 10 seconds.
3. How to check power capacity of Energy Mouse 2
a. Press and hold
show the power capacity.
4. How to turn off Energy Mouse 2 when charging is finished
a. Just remove the charger cable. Energy Mouse 2 will
automatically turn off automatic off in 10 seconds.
GM-130024/T
button for two seconds for the power level. The four LEDs will
- 1 -
English