Table of Contents
Advertisement
Quick Links
Wireless Mouse
Model : GM-03018U/T, GM-03018U/R
Hardware Installation
1.
You can connect the receiver to a USB port of a PC
2.
Install two AAA batteries in the mouse.
3.
Turn on your computer.
4.
After you open Windows, please press the button on t he receiver first and then press the button under the
mouse for channel setting.
Important: Remember do not put the batteries in the wrong direction, use the same types of batteries. Also,
keep all drinks away! If any spill occurs on the receiver, unplug the USB connector first and clean the
receiver immediately. Please remove the batteries if you do not use this device for at least two weeks.
Warning: (Troubleshooting)
1.
Please do not use Wireless Mini Navigator on a desk which is made of glass, mirror, iron, or black velvet.
Also, a flat surface is necessary or the Optical Sensor will error easily. When you use Wireless Mini
Navigator on a desk that is made of metal, try using a pad and reduce the receiving distance.
2.
Before the first installation is completed (channel setting ready), the mouse will not work in DOS.
3.
The Wireless Mini Navigator channel provides 256 ID-codes, and it automatically selects the ID # for your
mouse. You can only set up one Wireless Mini Navigator at a time. But if you have additional Wireless
Mini Navigator sets in an area of 10 square meters, more interference will occur between the receiver and
your mouse.
4.
If you feel the mouse does not move smooth as usual, then the batteries have lost their charge, so please
replace them. Also, the wireless icon will be blinking "red" when there is a battery-low situation. The LED
on the receiver shows the battery-recharging status (from shining to LED completely "on" for battery full).
You should set up the channel every time you replace the batteries.
5.
The Wireless Mini Navigator with radio frequency gives you free movement and an enjoyable experience.
For optimal performance, place the receiver at least 8 inches (about 20 cm) away from the mouse and other
electrical devices, such as the computer, monitor, and etc.
Software Installation
1.
Make sure the mouse is connected to the computer.
Advertisement
Table of Contents
Related Manuals for Genius GM-03018U/T
Summary of Contents for Genius GM-03018U/T
- Page 1 Wireless Mouse Model : GM-03018U/T, GM-03018U/R Hardware Installation You can connect the receiver to a USB port of a PC Install two AAA batteries in the mouse. Turn on your computer. After you open Windows, please press the button on t he receiver first and then press the button under the mouse for channel setting.
- Page 2 Put the Setup disk (or CD) into the disk drive. Follow the instructions on the screen to finish the software installation. Factory Setting/ faceplates changng Button Assignments The Button Assignment feature lets you work in a more efficient way because you can assign the most frequently used commands in Windows to the mouse buttons.
- Page 3 Supports all applications that use scrollbars, including Office, with zoom, Auto-panning, and scrolling functions. About Click here to open the Genius Homepage “www.geniusnet.com.tw” Orientation This function lets you set the angle when you move the mouse upward. It gives you a more comfortable angle when holding the mouse.
- Page 4 The buttons in “EasyJump Options” are especially used for Internet. The default function is “Open Browser” (button like ). You can select other functions from “EasyJump Options” in the “Settings” folder of the Genius Mouse Control Panel. The functions in “EasyJump Options” are: “Add to Favorite [IE] ”...
- Page 5 FCC Compliance and Advisory Statement This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the GM-03018U/T and is the answer not in the manual?
Questions and answers