Operation & Maintenance - Titan SDML-1000D Installation, Operation & Maintenance Manual

OPERATION & MAINTENANCE
* TEST THE LIFT SEVERAL TIMES FOR PROPER OPERATION BEFORE ATTEMPTING TO LIFT A LOAD.
1. All moving parts have been lubricated at the factory and should be re-lubricated before
the first use and at least once every six months to prevent damage. Grease fittings are
located at each frame pivot shaft and at the top ends of the inside frame assembly.
2. Lightly oil cylinder rod at least once every six months or when it becomes dry.
3. Squirt some oil through the bleed hole in the plate at the end of the cylinder to lubricate
piston and seal every six months.
4. The pivot shaft set screws should be checked frequently to be sure they are tight. These
are located at the top end of the inside frame assembly.
5. Do NOT use this product if worn or damaged. Examine lift for structural cracks, bends,
or other signs of damage prior to each use. Check all hoses and connections before
each use to ensure proper working condition.
6. Keep lift clean, dry, and well maintained to extend longevity of the product.
7. Roll motorcycle onto Deck Plate (57) until wheel is inside the Clamp (84 & 63).
8. Tighten the clamp to the tire by using the crank handle on the Moveable Clamp (60).
9. Load must be centered on the table at all times.
10. Load must be firmly positioned and secured on the table at all times.
11. To raise the lift, make sure that the compressed air is connected and use the Foot
Operated Air Valve (1) until you reach the desired working height.
12. IMPORTANT: After reaching the desired working height, lower the lift so that the Safety
Bar (46) sits firmly in the safety latch and all pressure is off of the Cylinder (20). Remove
air supply from Foot Operated Air Valve (1).
13. When finished working, attach air supply to Foot Operated Air Valve (1), raise the lift to
release the Safety Bar (46) and place it back into Deck Plate (57). Slowly release the air
from the Cylinder (20) until the lift rests gently on the ground.
The warnings, precautions and instructions in this manual cannot
cover all possible conditions and situations that may occur. The
operator must understand that the operator must supply common
sense and examine caution factors when using this product to
determine safety in all circumstances being used.
*REFER TO PARTS LIST FIG. 1
WARNING
2