Water connection
Connecting the water supply
Disconnect the appliance from the
power supply before establishing the
mains water connection.
A tap with a ¾ thread is required for
connection to the water supply.
Before using the appliance for the first
time, the water pipes should be purged
of air by a qualified and competent
person:
– To do so, the stainless steel hose
should be filled with as much water
as possible before being connected
to the solenoid valve.
– Mop up any spillages with a cloth.
Connect the straight end of the
stainless steel hose to the tap.
Ensure that it is screwed into
position correctly.
66
The stainless steel hose should be
attached to the solenoid valve at the
base of the rear of the appliance.
Secure the stainless steel hose to the
appliance housing with the retaining
clip.
Ensure that all connections are
watertight.
Turn on the tap slowly and check the
whole water system for leaks.
The appliance can now be connected
to the power supply (see "Electrical
connection").
Push the appliance into its final
position.
When doing so, make sure that the
stainless steel hose is not kinked or
damaged.
After a maximum of 24 hours the first
ice cubes will drop out of the ice cube
maker and collect in the drawer.