Reassembly; Parts Ordering - Emerson Fisher Baumann 24003 Instruction Manual

24003 Valve
January 2014

Reassembly

1. Place the plug and stem assembly (key 4) into the valve body (key 1) from the lower port and screw in the lower seat
ring retainer (key 5).
2. Place the bonnet (key 3) over the stem and tighten in place.
3. Insert the packing kit by following steps 4, 5, or 6 of Replacing Packing shown previously.
4. Place the actuator yoke over the stem and bonnet. While tilting the actuator back to allow access to the top of the
stem, place the yoke drive nut (key 8) over the stem.
5. Next, turn one locknut (key 27) onto the stem, turning it down as far as possible. Place the travel indicator (key 58)
over the stem and then turn the second locknut (key 27) down against the travel indicator (key 58). Counter turn
the locknuts to tighten securely.
See the following instruction manual (Baumann Actuator Instructions, D103352X012) for bench range adjustment.
CAUTION
When assembling or disassembling the valve, do not turn the valve stem while the plug is in contact with either seat. This
can damage the seating surface very quickly.
Table 1. Application Port
Service
Diverting
Mixing
1. C = common port, U = upper port, L = lower port

Parts Ordering

When corresponding with your Emerson Process Management sales office about this equipment, always mention the
valve serial number. When ordering replacement parts, also specify the key number, part name, and desired material
using the following parts tables.
WARNING
Use only genuine Fisherr replacement parts. Components that are not supplied by Emerson Process Management should
not, under any circumstances, be used in any Fisher valve, because they may void your warranty, might adversely affect the
performance of the valve, and could cause personal injury and property damage.
6
(1)
Inlet
C
U and L
Instruction Manual
D103357X012
Outlet
U and L
C