English - Bang & Olufsen Playmaker Manual

8
This guide contains information
about the installation and daily
use of your Bang & Olufsen
product.
The guide explains how to set it
up for use with AirPlay®,
DLNA®, line-in and connected
speakers. You can set up
Playmaker in a wireless network
using the BeoSetup App*
computer, or you can connect
Playmaker to a wired network
for immediate use. You can also
see how to connect other
sources to your Playmaker.
It is possible to set up and
synchronise multiple Playmakers
in your home. Contact your
Bang & Olufsen retailer for
more information.
You can find more information
about Playmaker in the Frequently
Asked Questions (FAQ) section on
www.bang-olufsen.com/faq.
*The BeoSetup App supports iOS
1
and Android devices only. Scan the
QR code on page 3 to download
the app.

English

How to get started
Before you connect any
equipment to your Playmaker,
make sure it is disconnected
from the mains supply.
You must remove the back cover
from Playmaker to access the
connection panel.
> Place Playmaker on a soft cloth
with the Bang & Olufsen logo
, your facing downwards.
1
> Remove the table stand
(if already mounted).
> Press firmly on the snap hook
and lift off the back cover.
> Run cables through the enclosed
cable cover.*
> Run cables through the hole in
the back cover.
> Connect Ethernet (optional),
line-in (optional) and speakers
before connecting the mains
cord.
> Reattach the back cover on
Playmaker. Make sure to align
the pivot points at the edges
before closing the back cover.
> Fit the table stand into the two
holes at the bottom of the back
cover. Run the cables above the
table stand.
Press firmly on the snap hook to
remove the back cover.
2
Make sure to align the pivot points
at the edges before closing the
back cover.
*If you want a wireless network
2
connection, do not run the
Ethernet cable through the cable
cover. For more information
about network connection,
see 'Network setup'.