Turning jets on & off Waterfall control handle – Air control handle – Main Diverter Aromatherapy control handle - My spa is too hot in summer Operating your Noosa Luxury spa Setting the time Setting the filter cycle Setting the temp control...
IMPORTANT SAFETY INSTRUCTIONS Your physiological response to hot water is very subjective and depends on your age, health and medical history. If you don’t know your tolerance to hot water or experience dizziness, headaches or nausea you should exit the spa immediately and cool down. WARNINGS Children in and around the spa should be supervised at all times by a responsible adult.
HYPERTHERMIA Since your spa can be set to reach temperatures of 40°C (104°F) users should be aware that extended submersion in water that exceeds normal body temperature can lead to hyperthermia. Hyperthermia occurs when the internal temperature of the body reaches several degrees above the normal body temperature of 37°C (98.6°F).
You will need a suitable electrical supply to run the spa. The Noosa Luxury Spa requires a hardwired 32Amp Residual Current Device Protected Dedicated Power Connection. Your Licenced Electrical Contractor can hardwire the spa straight to the meter box in your house or they can install a hardwired 32Amp residual current device protected dedicated isolation switch.
Page 6
3 Pin Plug not allowed Rotary Isolation Switch ELECTRICAL CONNECTION POINT LOCATION To hardwire the spa your Licenced Electrical Contractor will locate the electrical connection point here, unscrew and remove the cabinet panels directly underneath the spas touch pad.
IMPORTANT USAGE WARNINGS – NON WARRANTY FAULTS Spas are extremely delicate products and require regular maintenance. Below we will list a number of common causes of problems which are not covered under warranty. Should we ever need to visit you to repair your spa you will be charged the full cost of a repair if we found that the cause was the result of poor maintenance or customer negligence.
HOW TO REMOVE YOUR SPAS FILTERS WARNING: Be careful not to force the filter face past the waterfalls attached to the spa as this can break the waterfall fittings, if you apply a small amount of pressure to push the filter face away from the waterfall fitting as you remove the filter face you will clear the waterfall fittings without causing damage.
USING THE DRAIN The drain fitting has a locking keyway to stop the drain automatically opening. When you want to operate the drain fitting turn the handle clockwise and at the same time pull the handle away from the spa to release it from the locking keyway.
Page 21
AROMATHERAPY CONTROL HANDLE Your spa has an inbuilt aroma therapy stick which can be located on the spa image on page one. With all the pumps turned off unscrew the fitting from the spa and take out the stick. Remove the plastic transport cover by unscrewing the blue cap and sliding the opaque cover off to expose the scented stick inside, screw the blue cap back onto the aroma stick leaving the opaque cover off.
TROUBLESHOOTING UNLESS YOU HAVE THE APPROPRIATE ELECTRICAL LICENCE DO NOT OPEN THE SPAS COMPUTER BOX, PLEASE CONTACT THE STORE OF PURCHASE FOR DETAILS OF A LICENCED CONTRACTOR...
FROST PREVENTION SYSTEM If the temperature of the spas water drops below 5°C the spa will switch on the heater until the spa reaches the temperature of 8°C. OZONATOR The spas ozonator will automatically turns itself on and off when required, there are no adjustments you are able to make.
Need help?
Do you have a question about the Noosa and is the answer not in the manual?
Questions and answers