Siemens M55 User Manual page 116

M55 Barracuda fug am, A31008-H6300-A40-1-4A19 (20. May 2003, 16:01)
116
Store phone numbers and control
codes (DTMF codes) in the
Phonebook/Addressbook in the
same way as a normal entry.
J
Enter phone number.
0
Press until a "+" appears in
the display (wait for the
connection to be
established).
J
Enter DTMF codes
(numbers).
0
If necessary, wait again
for three seconds at a
time for the receiver to
process the entries safely.
J
Enter a name.
§Save§ Press.
You may also store just the
DTMF codes (numbers) and then
send them during the call.
Copy protection
Applications may be copy-protected.
Applications protected in this way
may only be run on devices for
which they are intended. It is,
however, always possible to create a
backup copy of these applications on
your PC using the "Siemens Data
Suite" (p. 123).
Notes A-Z
CSD connection
(Circuit Switched Data)
Data is transferred via a data
connection to a dial-in point pre-set
by your network operator or service
provider. This connection can be
used for exchanging data, such as,
for example, Internet access, or for
downloading games and
applications as well as for using WAP
services.
As long as you are using this
connection for downloading
applications from the Internet or
using services, you must pay
connection fees according to your
network operator's or service
provider's table of charges.
GPRS connection
(General Packet Radio Service)
GPRS is a new method for
transmitting data faster in the
mobile network. Use GPRS and if the
network has sufficient capacity, you
can be connected to the Internet
permanently.
Some service providers do not yet
support this service.
L