Hdd; Procedure 1 Message Check; Procedure 2 Partition Check; Procedure 3 Format Check - Toshiba Satellite L650 Maintenance Manual

2.5 HDD

2.5 HDD
To check if the 9.5mm or 12.5mm HDD is defective or malfunctioning, follow the
troubleshooting procedures below as instructed.

Procedure 1 Message Check

Procedure 2 Partition Check

Procedure 3 Format Check

Procedure 4 Test Program Check

Procedure 5 Connector Check and Replacement Check
CAUTION: The contents of the HDD will be erased when the HDD diagnostic test or
formatting is executed. Save the required contents of the HDD to floppy disks or other
storage drive in advance.
Procedure 1 Message Check
When the computer's HDD does not function properly, some of the following error messages
may appear on the display. Follow the steps below to check the HDD.
Check 1 If either of the following messages appears, go to Procedure 2. If the
following messages do not appear, perform Check 2.
Insert system disk in drive
Press any key when ready .....
or
Non-System disk or disk error
Replace and press any key
Check 2 Check SETUP to see if the Hard Disk option has been set to "Not used". If
so, choose another setting and restart the computer. If the problem
persists, go to Procedure 2.
Procedure 2 Partition Check
Boot from the DOS system. Perform the following checks:
Type C: and press the Enter key. If you cannot change to drive C,
Check 1
perform Check 2. If you can change to drive C, perform Check 3.
Type FDISK and press the Enter key.
Check 2
information" from the FDISK menu. If drive C is listed, perform Check 3.
If drive C is not listed, return to the FDISK menu and choose the option to
Satellite/Satellite Pro/L650/L655 Maintenance Manual
2 Troubleshooting
Choose "Display partition
2-11