Tunstall Fall Detector Instructions For Use Manual page 9

All the reassurance you need
Radio Approval Notices
Australia
The Fall Detector operates on a frequency of 312MHz and
is certified approved by TRL Compliance to
AS/NZS 4268:2003
Canada
Canadian Certification Approvals Number
IC: 1231A-66004A
USA
Federal Communications Commission (FCC) notices
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
in a residential installation.
equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no
guarantee that interference will not
occur in a particular installation. If this
equipment does cause
interference to radio or
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
D66070xx Issue A
Fall Detector Radio Trigger
Model Numbers
66004/01
66004/02
66004/03
66004/04
This
FCC ID: G2X-66004A
This Device complies with Part 15
of the FCC Rules.
Operation is subject to the following
two conditions:
(1) This device may not cause
harmful interference, and
harmful (2) This device must accept any
television interference
interference
undesired operation.
Warning
Changes or modifications to this
unit not expressly approved by the
party responsible for compliance
could void the user's authority to
operate the equipment.
received, including
that may cause
Page 9 of 10