Advertisement
EC ON ELECTROMAGNETIC COMPATIBILITY.
Functioning and use
Please note: pull out the support outwards by placing
fingers in the slot (see figure on page 3). If the support isn't
pulled out, the product will not stand up and fall down.
Always operate the heater in upright position only.
Any other position could create a hazardous situation.
1. Plug the appliance into the outlet.
2. Turn the thermostat dial to maximum.
3. Summer mode (fan only): turn the function selector to
the
position (the indicator light will go on).
4. Low power operation: turn the function selector to posi-
tion 1 (the indicator light will go on).
5. High power operation: turn the function selector to po-
sition 2 (the indicator light will go on).
6. Switching off: turn the function selector to the "0" posi-
tion (the indicator light will go off).
Setting the thermostat
Position the thermostat on maximum.
When the room has reached the required temperature, turn
the thermostat dial slowly counterclockwise until you hear a
click and the fan goes off (the indicator light stays on). The
thermostat will then keep room temperature at the selected
level automatically.
TROUBLESHOOTING
PROBLEM
The appliance doesn't work
Frost prevention mode
With the function selector in position 2 and the thermostat
dial in position
ture at about 5°C (41°F), preventing freezing with minimal
energy consumption (the indicator light will stay on).
MAINTENANCE
-
-
-
SAFETY FUNCTIONS
-
-
CAUSE
Be sure it is plugged in and that the
electrical outlet is working.
Check for any obstruction.
The function selector is in the "0" po-
sition.
The thermostat may be set too low.
The tip-over switch has been activated
(certain models only).
12
, the appliance maintains room tempera-
Always unplug from the outlet before cleaning.
Clean the air intake and outlet grilles regularly.
Do not use abrasive products or solvents to clean the
appliance.
Safety device: the appliance is fitted with a safety
device that switches it off in the event of accidental
overheating (e.g. obstruction of air intake and outlet
grilles, motor turning slowly or not at all).
To reset, unplug the appliance from the outlet for a few
minutes, remove the cause of overheating, then plug in
again. If the appliance doesn't work please contact the
De'Longhi Customer Service.
Tip-over safety device: certain models are fitted
with a tip-over switch (D) which turns the appliance off
if it falls over. To restart the appliance, simply place it
upright again.
Plug into the outlet.
Remove the obstruction, unplug the
heater and let the appliance cool down.
If the appliance doesn't work please
contact the De longhi toll free number.
Turn the function selector to the position
or "1" or "2".
Turn the thermostat clockwise to a higher
setting until the heater restarts.
Make sure the appliance is standing
upright on a flat surface, if the problem
persists contact our toll free number to
assist you.
SOLUTION
Advertisement
