Advertisement
Operations
6. To begin cleaning with attachments, follow
instructions on page 8 for filling 2-in-1 water tank.
7. Set ReadyTools dial to TOOLS setting. This will
allow spray and suction from hose.
8. Attach cleaning tool of your choice to end
of hose. If using a Tough Stain Deep Reach Tool,
follow directions below.
9. Hold tool approximately 2.5 cm above soiled
surface. Press spray trigger to apply cleaning
solution to soiled area. Using brush on tool,
gently scrub area to be cleaned. Release spray
trigger, apply downward pressure on tool
and pull it toward you to suction up dirt and
cleaning solution. Continue until no more dirt can be
removed. Caution: Do Not Overwet.
10. When finished cleaning, remove and rinse tool(s)
in clean, running water.
11. It is recommended that you suction clean water
from the tap to rinse out the hose. Be careful not to
over-fill your tank.
12. Before wrapping hose onto rack, lift end of hose
and stretch to ensure all water is cleared from hose.
13. Wrap hose around rack.
14. Empty 2-in-1 water tank and rinse out,
following instructions on page 9.
15. If ReadyTools dial becomes difficult to turn, the
diverter assembly that holds dial may need to be
cleaned. To clean, first remove nozzle and locate
screw that holds diverter assembly in place. With a
Phillips screwdriver, remove the screw and set aside.
16. Remove diverter assembly; hold under running
water making sure water flows through and around
dial. Turn dial about 10 times clockwise and 10 more
times counter clockwise to free up debris.
17. Wipe diverter assembly with a soft cloth and
place back on machine. Replace nozzle.
18. Return ReadyTools dial to FLOOR CLEANING.
Cleaning with Tough Stain Deep Reach Tool
1. Set tool on soiled surfaces and press spray trigger
to spray solution onto soiled area to be cleaned.
2. Slowly move tool back and forth over soiled
surface, keeping tool in contact with carpet.
3. Release spray trigger and move tool slowly over
soiled area to suction up water and dirt.
4. Continue to clean the area, working in small
sections, until no more dirt can be removed.
5. The front nozzle of the Pet Stain Tool can be
removed for easy cleaning. Push the button at the
top of the cleaning tool and slide the front nozzle
off the top of the cleaning tool. Rinse the front
nozzle and the tool with clean water and replace
front nozzle back onto the tool.
10
www.BISSELL.com
7.
11.
12.
15.
16.
1.
3.
5.
Hide quick links:
Advertisement
