Advertisement
Dear Customer,
If you have any questions concerning the installation of your
Banks Dual Gauge Pod, please call our Technical Service Hotline
(888) 839-2700 between 7:00 am and 4:00 pm (PT).
If you have any questions about shipping or billing, please contact our
Customer Service Department (888) 839-5600.
Thank you.
1.
Before starting work, familiarize
yourself with the installation
procedure by reading all of the
instructions.
2.
The exploded views (See Figure
1 & Figure 2) provide only general
guidance. Refer to each step and
section diagram in this manual for
proper instruction.
1.0 ASSEMBLY
1.
Insert the Nut
into the bottom of
the Gauge Pod.
See Figure 3.
2.
Slide the Gauge
Pod into the
Dual Gauge Pod
Connector, and line
up the holes from the top. Now, insert
the bolts from the top and tighten
down. See Figure 4.
Figure 4
3.
into the back of the Dual Gauge Pod
Connector. See Figure 5 Make sure
the orientation of the friction pad is
correct. See Figure 6.
Figure 5
Figure 6
Figure 3
4.
Mount Arm, then push the Dual Gauge
Pod Connector and the Mount Arm
together. After, tighten the nut. See
Figure 7.
Figure 7
Insert the rubber friction pad
Place the nut on the head of the
3
97678 v.1.0
Advertisement
