Setting The Auto-Mount Parameters - Hitachi Universal Storage Platform V Configuration Manual

Setting the Auto-Mount Parameters

The final step in configuring the USP V devices for SGI IRIX operations is to
set the auto-mount parameters for the new devices. For each device to be
auto-mounted, you will add the device to the system auto-mount table
(/etc/fstab file). If you do not plan to auto-mount any of the USP V devices,
you can skip this section.
To add new devices to the system auto-mount table:
1. First make a backup copy of the mount table: cp /etc/fstab
/etc/fstab.backup
2. Add each desired new device to the mount table as shown in
Table 3-2
# cp /etc/fstab /etc/fstab.backup
# vi /etc/fstab
/dev/root
/dev/dsk/dks8d0l15s0 /DKC310_LU00 xfs rw,noquota
:
Figure 3-7
Table 3-2
No.
Device to mount (device file name)
Mount point (mount directory)
File system (FS) type
Mount options (usually [rw,noquota])
Enhance – enter 0 for USP V devices
fsck pass – order in which FS checks are to be performed
Hitachi Universal Storage Platform V/VM Configuration Guide for SGI
describes the auto-mount parameters.
/ xfs rw,raw=/dev/rroot 0 0
Setting the Auto-Mount Parameters
Auto-Mount Parameters
Description
Configuring the New Disk Devices
Figure
← Make backup.
Edit mount table.
0 1 Enter new device.
See Table 3-2.
® ®
IRIX Host Attachment
3-7.
3-11