Installation And Configuration Roadmap - Hitachi Universal Storage Platform V Configuration Manual

Installation and Configuration Roadmap

The steps in
install and configure the USP V on an SGI IRIX operating system.
Table 1-4
1. Verify that the system on which you are installing the USP V meets the minimum
requirements for this release.
2. Prepare the USP V for the installation.
3. Prepare the fibre-channel HBAs for the installation.
4. Connect the USP V to an SGI IRIX host.
5. Verify recognition of the new devices.
6. Partition the disk devices and enable command tag queuing.
7. Create the file systems and mount directories, and mount the devices,.
8. Verify the file systems and set the auto-mount parameters.
1. Verify
Minimum
Requirements
5. Verify
Recognition of
the New Devices
Figure 1-1
Hitachi Universal Storage Platform V/VM Configuration Guide for SGI
Table 1-4 and F igure 1-1
1
Installation and Configuration Roadmap
2. Prepare the
USP V System
6. Partition Disk
Devices/Enable
Command Tag
Queuing
Installation and Configuration Roadmap
Introduction
outline the general process you follow to
Task
3. Configure the
Fibre-Channel
HBA(s) SGI IRIX Host
7. Create the File
Systems and Systems and Set
Mount
Directories
®
IRIX
4. Connect
USP V to the
8. Verify File
Auto-Mount
Parameters
1-11
®
Host Attachment