Simplicity SMI I924E Operator's Manual page 7

discharge angle.
18. Never direct discharge at bystanders or allow
anyone in front of the unit.
19. Never leave a running unit unattended. Always
disengage the auger and traction controls, stop
engine, and remove keys.
20. Do not operate the unit while under the influence of
alcohol or drugs.
21. Keep in mind the operator is responsible for
accidents occurring to other people or property.
22. Data indicates that operators, age 60 years and
above, are involved in a large percentage of power
equipment-related injuries. These operators
should evaluate their ability to operate the unit
safely enough to protect themselves and others
from injury.
23. DO NOT wear long scarves or loose clothing that
could become entangled in moving parts.
24. Snow can hide obstacles. Make sure to remove all
obstacles from the area to be cleared.
CHILDREN
Tragic accidents can occur if the operator is not alert to
the presence of children. Children are often attracted to
the unit and the operating activity. Never assume that
children will remain where you last saw them.
1. Keep children out of the area and under the
watchful care of another responsible adult.
2. Be alert and turn unit off if children enter the area.
3. Never allow children to operate the unit.
4. Use extra care when approaching blind corners,
shrubs, trees, or other objects that may obscure
vision.
CLEARING A CLOGGED DISCHARGE
CHUTE
Hand contact with the rotating impeller inside the
discharge chute is the most common cause of injury
associated with snowthrowers. Never use your hand
to clean out the discharge chute.
To clear the chute:
1. SHUT OFF THE ENGINE.
2. Wait 10 seconds to be sure the impeller blades
have stopped rotating.
3. Always use a clean out tool, not your hands.
SERVICE, MAINTENANCE, AND STORAGE
1. Check shear bolts and other bolts at frequent
intervals for proper tightness to be sure the
equipment is in safe working condition.
2. Never store the machine with fuel in the fuel tank
inside a building where ignition sources are present
such as hot water and spacer heaters, or clothes
dryers. Allow the engine to cool before storing in
any enclosure.
3. Always refer to the operator's manual for important
details if the snowthrower is to be stored for an
extended period.
4. Maintain or replace safety and instruction labels as
necessary.
5. Run the machine a few minutes after throwing
snow to prevent freeze-up of the collector/impeller.
6. If fuel is spilled, do not attempt to start the engine
but move the machine away from the area of
spillage and avoid creating any source of ignition
Safety Rules and Information
until fuel vapors have dissipated.
7. Always observe safe refueling and fuel handling
practices when refueling the unit after
transportation or storage.
8.Always follow the engine manual instructions for
storage preparations before storing the unit for
both short and long term periods.
9. Always follow the engine manual instructions for
proper start-up procedures when returning the unit
to service.
10. Maintain or replace safety and instruction labels as
necessary.
11. Keep nuts and bolts tight and keep equipment in
good condition.
12. Never tamper with safety devices. Check their
proper operation regularly and make necessary
repairs if they are not functioning properly.
13. Components are subject to wear, damage, and
deterioration. Frequently check components and
replace with manufacturer's recommended parts,
when necessary.
14. Check control operation frequently. Adjust and
service as required.
15. Use only factory authorized replacement parts
when making repairs.
16. Always comply with factory specifications on all
settings and adjustments.
17. Only authorized service locations should be utilized
for major service and repair requirements.
18. Never attempt to make major repairs on this unit
unless you have been properly trained. Improper
service procedures can result in hazardous
operation, equipment damage and voiding of
manufacturer's warranty.
19. Check shear bolts and other bolts at frequent
intervals for proper tightness to be sure the
equipment is in safe working condition.
EMISSIONS
1. Engine exhaust from this product contains
chemicals known, in certain quantities, to cause
cancer, birth defects, or other reproductive harm.
2. If available, look for the relevant Emissions
Durability Period and Air Index information on the
engine emissions label.
IGNITION SYSTEM
1. This spark ignition system complies with Canadian
standard ICES-002.
7