Electrolux EVEP916 Installation & User Manual page 5

8 electrolux.com.au
BEFORE USING THE APPLIANCE
Preparing the appliance
1. Please remove all stickers, leaflets and boxes from
the door and from the floor of the oven before
operation.
2. Please wipe out the oven interior prior to operation
with warm soapy water and polish dry with a soft
clean cloth. Do not close the oven door until the
oven is completely dry.
3. Do not line the oven with foil. It will damage
the enamel.
Setting the time
The time of day must be set before the appliance can
operate.
After the appliance has been electrically connected "Set
Clock" will illuminate under the clock display and the Hour
digits will flash.
1. Use the timer + and - to set the hour portion of the
current time (including AM/PM).
2. Press OK when the hours are set correctly. The
Minute digits will flash.
3. Use the timer + and - to set the minutes portion of
the current time.
4. Press OK when the minutes are set correctly. You
can turn off the oven or it will do so after 8 seconds.
Once the time has been entered, the clock advances
minute by minute.
IMPORTANT!
• The clock will remember the time for 24 hours
without power.
• The display has 2 levels of brightness.
• Brightest illumination: whenever the oven is in use.
• Medium illumination: whenever the oven is not in use.
IMPORTANT!
New appliances can have a smell during first use.
It is recommended to 'run in' the oven before you
cook for the first time. Operate the oven, empty, at
a temperature of 180ºC for approximately 1 hour.
Please ensure the room is well ventilated during
this process.
BEFORE USING THE APPLIANCE
(CONTINUED)
Slides (Telescopic runners)
1. The oven is supplied with a set of slides and
instructions on how to assemble. Ensure the rack
and slides are of the same hand. E.g. left hand
slide should be fitted on the left hand rack.
2. The instructions also show recommended slide
positions on the rack.
Installing the slides (telescopic runners)
1. Obtain left hand side rack and left hand slide –
see image to identify.
L = Left hand side
R = Right hand side
2. The shaded wires indicate the wire the slide can
be mounted on. Fit slide rear clips to the rear of
wire at an angle as shown below.
1
3. Push slide front clip over wire until secured.
CLICK!
Installing the side racks
1. Insert the rear peg into the rear access hole provided,
ensuring peg is fully inserted.
2. Then locate the front peg into the front access hole
and push in firmly.
Fitting the shelves and grill dish carrier between
the side rack wires
The shelves are designed so that they have maximum
extension but cannot be accidentally pulled right out. The
grill dish carrier is designed the same way and can slot
straight into the side racks.
To fit a shelf or grill dish carrier to side racks:
1. Locate the rear edge of the shelf/carrier in between
guide rails of the side rack - see diagram.
2. Ensure the same rail positions on both sides of the
oven are being engaged. With the front edge raised,
begin to slide the shelf into the oven.
3. Once the detents have passed the front edge of
the side rack, the shelf can be pushed completely
2
in. When fully inserted the shelf/carrier should not
interfere with the closed oven door.
3
9