Electrolux EVEP916 Installation & User Manual page 6

90cm cooker
Hide thumbs Also See for EVEP916:
Table of Contents

Advertisement

10
electrolux.com.au
Positioning the dishes on the grill dish carrier
Fitting the shelves and grill dish carrier onto
telescopic slides
To fit a shelf or grill dish carrier to telescopic slides:
1.
With the slides fully pushed in, push the shelf/carrier
along the top of the slide until it hits the back post.
2.
Drop the front of the shelf/carrier ensuring it sits
behind the front post of the slide (see illustration).
When fully inserted the shelf/carrier should not
interfere with the closed oven door.
BEFORE USING THE APPLIANCE - GAS HOB MODEL
Installing the trivets
1.
Position the 2 side trivets onto the hob first, ensuring
the 2 corner location recesses are to the back of the
hob.
1
5
6
7
8
9
Side trivet
Standard burner cup
1
7
2
Wok support
8
Standard burner spark plug
3
Middle trivet
9
Standard burner flame
safeguard sensor
4
Side trivet
Wok burner flame safeguard sensor
10
5
Standard burner cap
11
Wok burner spark plug
Standard burner crown
6
Installing the standard burners
1.
The burner crown must be fitted correctly onto the
burner cup or damage will occur during operation.
2.
To do this, align the outer hole and outer recess of
the burner crown around the spark plug and flame
safeguard sensor. Drop down ensuring the location
ribs on the bottom of the crown drop into the
location recesses.
3.
Burner cap and burner crown must be clean and
located correctly for the burner to light.
2.
Position the middle trivet ensuring the trivet fingers
are aligned with the side trivet fingers.
3.
The wok support sits on top of the trivet above the
wok burner.
2
3
4
10
11
Wok burner inner cap
12
13
Wok burner outer cap
14
Wok burner crown
15
Wok burner body
Installing the wok burners
1.
The wok burner crowns must also be fitted correctly
onto the wok burner cups.
2.
To do this, align the sausage shaped cutouts on the
burner crown with the sausage shaped cutouts on
the burner body. Drop down ensuring the centre
location pin of the crown has dropped into the
corresponding recess in the body.
3.
The 2 burner caps are simply positioned over the
top of the burner crown.
NOTE: When the burners are correctly fitted they will sit
level on the hob.
11
12
13
14
15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Efep915Efep955

Table of Contents