Displayport In / Displayport Out Terminal Connection - Panasonic TH-98SQ1W Operating Instructions Manual

Note
● Component video signal is supported with this
terminal (Mini D-sub 15P).
Change the [Component/RGB-in select] setting in
the [Signal] menu to [Component] (when Component
signal connection) or [RGB] (when RGB signal
connection). (see page 55)
●
Additional computer, cables and conversion adapter
shown are not supplied with this set.
●
If the computer being connected is not DDC2B-
compatible, you will need to make setting changes to
the computer at the time of connection.
●
Do not set the horizontal and vertical scanning
frequencies for PC signals which are above or below
the specified frequency range.
●
For audio, the AUDIO IN 1 / AUDIO IN 2 terminal can
be used. (For [Audio input select] function, see page
66.)
Pin assignments and signal names for PC Input
Terminal (Mini D-sub 15P)
5 4
10
15 14 13 12 11
Pin No.
R (P /C
R
G (Y)
B (P /C
B
NC (not connected)
GND (Ground)
GND (Ground)
GND (Ground)
GND (Ground)
+5 V DC
GND (Ground)
NC (not connected)
SDA
HD/SYNC
VD
SCL
3 2 1
9 8 7 6
Signal Name
)
R
)
B
DisplayPort IN / DisplayPort OUT
terminal connection
DisplayPort cable (commercially available)
PC with DisplayPort output
Note
● For audio, it is also possible to use the AUDIO IN
1 / AUDIO IN 2 terminal. (For [Audio input select]
function, see page 66.)
●
Depending on the device to be connected, it may take
time for images to be displayed.
●
Please use DisplayPort 1.2 compliant cable.
● Depending on the types of cable or mini connector
adaptor used, 4K picture may not be displayed.
● In connecting with PC which uses early chipsets
or graphic cards compatible with DisplayPort, if the
DisplayPort output of the PC is connected to this unit,
malfunction of this unit or the PC may occur. In that
case, turn the power of the unit or the PC off, and
then turn it on again.
When inputting DisplayPort output to this unit, it
is recommended to use the PC which the newest
Chipset and Graphics Cards are used.
23
English