Table of Contents
Advertisement
OPERATION
• Keep hands and feet away from rotating parts. Keep
clear of discharge opening at all times.
• Always clear snow up and down the face of slopes,
never across the face. Use extreme caution when
changing direction on slopes. Do not attempt to clear
slopes over 17.7% (10
• Use extreme caution when operating on or crossing
drives, walks or roads. Stay alert for hidden hazards
and traffic.
• Be especially careful not to touch snowthrower parts
which might be hot from operation. Allow such parts
to cool before attempting to maintain, adjust or ser-
vice.
• If unit starts to vibrate abnormally, disengage drives
and stop the engine. Check immediately for the
cause. Vibration is generally a warning of trouble.
• Before leaving operator's position for any reason:
- shut off engine,
- remove the Engine Key and
- wait for all moving parts to stop.
• Before cleaning, repairing or inspecting the unit,
make certain all moving parts have stopped. Remove
the key to prevent accidental starting.
• Always use a grounded, 3-wire plug receptacle for
electric starting.
• Adjust snow discharge angle for safe flow when oper-
ating near glass enclosures, automobiles, window
wells, dropoffs, etc.
• Do not overload machine capacity by clearing snow
at too fast a ground speed.
• Never operate machine at high transport speeds on
slippery surfaces. Use care when backing up.
• Disengage Auger Control when transporting or not in
use.
• Never operate the snowthrower without good visibility
or light. Always be sure of your footing.
• Do not change the engine governor settings or over-
speed the engine.
• Never direct the discharge chute at bystanders; nor
allow anyone in front of the unit while it is operational.
• Never operate this machine without all of the proper
guards or other safety protective devices in place.
o
.
)
Safety Rules & Information
MAINTENANCE & STORAGE
• Keep all nuts, bolts and screws tight to ensure that
the equipment is in safe operating condition.
• Never store equipment with gasoline in the tank in a
building where fumes may reach an open flame or
spark. Allow the engine to cool before storing in any
enclosure.
• Always refer to the Operator's Manual for important
details if snowthrower is to be stored for an extended
period.
• Run auger drive a few seconds after completion of
throwing snow to help clear out snow and prevent
icing and freeze-up on unit.
3
Advertisement
Table of Contents
