Troubleshooting & Service Troubleshooting; Removing Engine Cover - Simplicity 1692917 How To Use Manual

Problem
Engine fails to start
Engine starts hard or runs poorly
Unit does not throw snow
Auger does not stop turning
when control is released
Excessive vibration
Note: For repairs beyond the minor adjustments listed above, please contact your local Simplicity dealer.

REMOVING ENGINE COVER

Note: In many of the following adjustment and service
tasks, it will be necessary to remove and reinstall the
engine cover. To remove the cover, proceed as follows:
1. Remove the Engine Key from the switch.
2. Remove the two rear fasteners securing the back of
the cover housing. (Figure 11).
3. Remove the fuel tank cap.
4. Remove the cover (see Figure 12 on page 14).
5. Temporarily reinstall the fuel tank cap.
6. Perform the adjustments or service desired.
7. Reinstall the cover by reversing the removal steps.
Note: The tabs at the lower front of the cover must be
positioned correctly.
WARNING
To avoid the possibility of serious bodily injury when
performing adjustments, maintenance or lubrication,
stop engine and remove key from switch.
TROUBLESHOOTING
Possible Cause
1. Key is OFF
2. Failure to prime cold engine
3. Out of fuel
4. Choke OFF - cold engine
5. Engine flooded
6. Spark Plug not sparking
7. Water in fuel, or old fuel
1. Fuel mixture too rich
2. Spark plug faulty, fouled,
or gapped incorrectly
3. Water in fuel, or old fuel
4. Gas cap vent hole plugged
1. Loose or broken drive belt
2. Incorrect control cable
adjustment
3. Discharge chute clogged,
foreign object lodged in auger
4. Broken control cable
1. Incorrect control cable
adjustment
1. Loose parts or damaged
auger
Figure 11. Remove and/or loosen Cover Screws
13
Troubleshooting
& Service
Remedy
1. Turn Key to the ON position
2. Press primer button twice and restart.
3. Fill fuel tank
4. Turn Choke to ON.
5. Turn Choke to OFF; try starting
6. Check Gap. Gap plug, clean electrode,
or replace as necessary
7. Drain tank (Dispose of fuel at an authorized
waste facility). Fill with fresh fuel mixture.
1. Move choke to OFF position
2. Clean and gap, or replace
3. Drain tank (Dispose of fuel at an authorized
waste facility). Fill with fresh fuel mixture.
4. Clean vent hole or replace cap
1. Adjust or replace belt
2. Adjust Auger Control cable
3. Stop engine, remove key and
clean out discharge chute
4. Replace cable
1. Adjust Auger Control cable
1. STOP engine and REMOVE the key,
tighten all hardware. If vibration
continues, see your dealer.
Remove
Fuel Tank
Cap
Remove two
rear fasteners
securing
cover