Summary of Contents for Rentokil Lumnia Compact US
Page 1
Lumnia Compact US - Instruction Manual This manual is based on the latest information and is provided subject to alteration. We reserve the right to change the construction and/or configuration of the product and versions at any time without obligation.
Page 2
1. Safety Warning SAVE THESE INSTRUCTIONS The lamp in this unit produce ultraviolet (UV) light, which can cause skin or eye damage if viewed directly for a long period. Only fit the correct type of UV lamps in the unit. The unit shall be installed and serviced by individuals with appropriate qualifications and/or experience in accordance with national regulations in the country of operation and...
Page 3
3. Equipment for Installation In the Box: Equipment Required for Install A3 drilling template – Supplied in Box 1. Lumnia Compact US: 304856 Screw Fix Kit – Supplied In Box Also includes x1 UV-LED Lamps 304816 Spirit Level advised. – Not Supplied 2.
4. Installation Instructions: Connecting the Power Source DANGER: You must NOT connect the unit into a lighting circuit. WARNING: You must connect the power cable to a standard power socket. DANGER: SERVICING OF DOUBLE-INSULATED APPLIANCES In a double-insulated appliance, two systems of insulation are provided instead of grounding. No grounding means is provided on a double-insulated appliance, nor should a means for grounding be added to the appliance.
5. Positioning the Unit Position the unit on a suitable wall at a minimum Figure 1: height of 1.86 metres to the bottom of the unit. Figure 1 illustrates the suggested mounting height. Position the unit as far as possible from sources of ambient light.
For safety reasons, the unit contains a micro switches that disables the UV lamps if you open the Front Louvre. Figure 2 indicates the size and space considerations for louvre cover opening sweeps at 90°. 132mm 225mm 155mm Figure 2: DO NOT position the unit directly over areas where food is prepared, or where uncovered food is stored.
7. Installation Preparation Ø6mm 1.86M 8. Opening the Louvres...
Page 8
9. Mounting Lumnia NOTE: Remove lamps before screwing See Section 14 for more details on lamp removal SECURE WITH Tighten ALL 3x SCREWS 10. Preparing the Glue Board Fold Flex Remove Liner...
Page 9
11. Installing & Removing the Glue Board Installing Installed Removing 12. Lumnia Performance Table Power Setting Low ( I ) Medium ( II ) High ( III ) Ambient Light < 300 300 - 750 750 + Level (LUX) Warehouses, Normal Office Supermarkets, Home,...
Page 10
14. Removing and Replacing the UV - LED Lamp For lamp identification refer to reference number on Lamp. Only Lamps specified in Section 15 - Accessories and Spares to be used with this product. Do not touch LED when servicing, maintaining or cleaning the lamps. Removing UV - LED Lamp 2.
The product described in this manual is subject to continuous development and improvement and Rentokil reserve the right to alter the specification or design without prior notice. Rentokil cannot accept any liability for any loss or damage arising from the use of any information contained within this manual, or from any incorrect use of the product described herein.
Page 12
Rentokil reserve the right to alter the specification or design without prior notice. Rentokil cannot accept any liability for any loss or damage arising from the use of any information contained within this manual, or from any incorrect use of the product described herein.