Bosch SGH182 Operating/Safety Instructions Manual page 8

REPLACING SCREWDRIVER BIT
AND BIT HOLDER
1. Remove the depth control by grasping firmly
WITH YOUR HAND and pulling straight out.
DO NOT USE PLIERS (Fig. 5a).
FIG. 5a
2. Remove the screwdriver tip by leveraging the
hole on the side of the depth control against
the bit and pull the bit out (Fig. 5b). Similarly,
to remove the bit holder, leverage the hole
on the side of the depth gauge against the
screwdriver bit and also grasp the bit holder
with fingers from the same hand and pull
both the bit and bit holder out. If necessary,
pliers may be also used to remove either of
those items (Fig. 6).
FIG. 5b
Screwdriver
bit
Depth control
FIG. 6
Screwdriver
bit
Depth control
Bit
Holder
Bit
Holder
Assembly
3. Install bit holder (if removed) and new
screwdriver bit.
4. Then using your HAND ONLY, reinstall
depth control. Push depth control onto tool
until it snaps into place.
Your tool is equipped with a belt clip that allows
you to conveniently attach your driver to your
belt. This feature will allow you to have both
hands free when climbing a ladder or moving to
another work area (Fig. 1).
Your tool is also equipped with a multi-bit
holder (not shown) that can be mounted to the
side of the tool opposite the belt clip.
MOUNTING THE OPTIONAL AUTO-FEED
1. Remove depth control and bit holder from the
tool.
2. Insert the special extended screwdriver bit into
the tool (Fig. 7).
3. Slide the auto-feed attachment MA55 over the
special extended screwdriver bit to the stop on
the motor housing (Fig. 7).
FIG. 7
Special Extended
Screwdriver Bit
INSERTING A SCREW STRIP
WARNING
pack from power tool before making any
adjustments, changing accessories, or
storing power tools. Such preventative safety
measures reduce the risk of starting the power
tool accidentally.
1. After auto-feed attachment has been mounted
-8-
BELT CLIP
MULTI-BIT HOLDER
ATTACHMENT
Auto-feed
Attachment
(MA55)
Disconnect the plug from the
power source and/or battery