Depth Adjustment - Bosch SGH182 Operating/Safety Instructions Manual

DEPTH CONTROL
The depth control should be adjusted so that
the drywall screw is set slightly below the
drywall surface.

DEPTH ADJUSTMENT

Your driver will continue to drive as long as
enough pressure is applied to the bit to keep
the clutch engaged. The depth control, upon
contacting the work, prevents further
pressure on the bit. Driving then stops
regardless of pressure continued by the
operator.
1. Rotate the depth adjusting sleeve until the
depth stop reaches the desired position.
2. Each click of the depth adjusting sleeve
equals a 1/64 inch change in depth. One
full 360 degree turn equals 1/16 inch (Fig.
10).
3. Before beginning, always test-drive a
sample screw into a piece of scrap
SGH182 with MA55 Operating Instructions
AUTO-FEED ATTACHMENT
Never place any part of your
body in a pinch point area.
WARNING
When operating auto-feed attachment consider
where your hand is located. If it is within a pinch
point, strongly consider an alternative position.
Injuries occur when hands or fingers are
between moving and stationary parts during the
pinching movement.
ADJUSTING FOR SCREW LENGTH
1. The auto-feed attachment must be adjusted
to match length of screw being used.
2. Depress adjustment button on side of auto-
feed attachment (Fig. 3).
3. Slide self-feed mechanism forward or
backwards to align arrow on the sliding
portion with the corresponding length printed
onto the auto-feed attachment (Fig. 3).
4. Allow depressed pin to snap back into place
by means of spring force.
DEPTH ADJUSTMENT
Your driver will continue to drive as long as
enough pressure is applied to the bit to keep
the clutch engaged. The auto-feed attachment
is capable of preventing further pressure on the
bit. Driving then stops regardless of the
pressure continued by the operator.
1. Turn the thumbwheel on the auto-feed
attachment downward to increase the depth
the screw will be driven (Fig. 4).
FIG. 10
Depth Adjusting
installation material to check desired depth
setting.
All available sharp-point screws in 14-25
gauge studs.
2. Turn the thumbwheel on the auto-feed
attachment upward to decrease the depth
the screw will be driven.
3. The selected depth is indicated symbolically
on the scale next to the thumbwheel (Fig. 4).
DRIVING SCREWS
Always work at a right angle to the work piece
to ensure the Auto-Feed mechanism is able to
operate properly. Failure to do so may cause
the Auto-Feed mechanism to jam or slip off the
screw head.
1. Depress trigger switch to engage the tool.
2. Set the work contact element on the auto-
feed attachment on the spot where the screw
is to be driven.
3. Apply uniform pressure to the tool in the
direction of the workpiece until the screw is
driven in.
4. By releasing pressure and disengaging tool
from driven screw, the next screw is loaded
Screws already driven cannot be removed or
retightened with the auto-feed attachment. To
remove or tighten screw, remove auto-feed
attachment and use tool without the
attachment.
Collated screws 1" to 2-1/8" in length, 3/8" max
head diameter and 3/16" max shank diameter.
-10-
Sleeve
CAPACITIES
CAPACITIES