Behringer FCA202 F-Control Operating Manual page 19

All manuals and user guides at all-guides.com
The ABOUT section gives information about the driver versions that are used. Compare the
version numbers given here with the drivers available via Internet from www.behringer.de.
If you have any problems, you should always try to install the newest driver software.
Use the LATENCY SELECT slider to set the desired latency. Click the APPLY button to accept
the selection made.
+
You can only set the latency from the CONTROL PANEL if you are using an ASIO
driver. Very short latency values can lead to audio dropouts. If this happens, pull
the slider further to the right so that you set up higher values. You’ll find further
information in Chapter 4.1.
The SAMPLING FREQUENCY selection menu allows you to set the sample rate for the digital
converter. The available frequencies are 44.1 kHz, 48.0 kHz and 96.0 kHz.
The wiring diagram is provided as additional information. It shows the signal flow in the
FCA202.
+
Depending on the audio software used, you may have to restart your application
in order to activate any changes that you made in the CONTROL PANEL. If you
want to be sure that your settings have been correctly accepted, configure
your Windows
®
system before you start the audio application.
3. OPERATING ELEMENTS AND CONNECTIONS
F-CONTROL AUDIO FCA202
®
19