Advertisement
Installation instructions for kick scooters
Step 1.
Make sure that cartoon is not damaged
Step 4.
Remove the tape holding front and rear wheel
Step 7.
Remove the protecting material from handlebars
Step 10.
In this step set the direction of the stem
roughly. You will align it precisely
later with the wheel on
series ACTIVE, URBAN, ROAD
Step 2.
Remove the kick scooter out of the box
Step 5.
Put wheels aside
Step 8.
Assemling of the kick scooter is only
in attaching wheels and handlebars
Step 11.
Tighten the screws on the stem with force 4 NM
www.kickscooters-crussis.eu
Step 3.
Wheels are attached to the frame
Step 6.
Remove the protecting material from frame
Step 9.
Loosen the screws on the stem
and align so that it faces forward while riding
Step 12.
Remove the screws from the front part
of the stem
Advertisement
Table of Contents
Related Manuals for CRUSSIS ACTIVE Series
Summary of Contents for CRUSSIS ACTIVE Series
- Page 1 Remove the screws from the front part In this step set the direction of the stem Tighten the screws on the stem with force 4 NM roughly. You will align it precisely of the stem later with the wheel on www.kickscooters-crussis.eu...
- Page 2 Stem and front wheel must form a single axis. We wish you many happy kilometers suit the angle of the brake levers. Make sure that stem is properly tightened on your new We recommend setting at 45 degrees with force 4 NM kick scooter CRUSSIS! www.kickscooters-crussis.eu...
Need help?
Do you have a question about the ACTIVE Series and is the answer not in the manual?
Questions and answers