Table of Contents
Advertisement
Reverse power connection:
Power is diode protected from voltage polarity reversal. Recovery is immediate and without
damage.
Installation
The servo system is mounted to the post with
careful alignment and bolted together.
Additionally, the payload (supplied separately)
must be attached to the SMS. The steps for this
process are described below and should be read
and understood before any installation or
assembly begins.
WARNING – Do not apply power until the
installation is complete!
Mounting:
Servo System:
The servo system is the part of the SMS that will hold the payload level and horizontal. The servo
system consists of the main servo housing and the sensor package mounting arm. The main servo
housing has a circular plate with M6 threaded holes. Four M6 bolts and four M6 washers are
provided to mount the servo system to its mounting place. Several steps should be followed for a
proper installation of the servo system:
1. The servo system is heavy and must be supported
during installation to its mounting place.
2. Adjust the position of the mounting ring of the servo
system so that the paint mark on the mounting ring
will line up with the center position of the intended
field of view.
Watson Industries, Inc.
SMS-P233 Rev B 10/17/2017
7
Stop Pin
Paint Mark
Advertisement
Table of Contents
