Precautions And Maintenance - A.O. Smith AO-WH-DSCLR Owner's Manual

Whole house descaler
Hide thumbs Also See for AO-WH-DSCLR:
Table of Contents

Advertisement

Available languages

Available languages

PRECAUTIONS AND MAINTENANCE

AO-WH-DSCLR
Rated service flow 7 gpm (26.5 Liters)
Max capacity 6 years
Min working pressure 20 psi (137.9 kPa)
Max working pressure 100 psi (689.5 kPa)
Min operating temperature 40° F (4.44° C)
Max operating temperature 90° F (32.22° C)
The exterior of your filtration system
can be cleaned with warm, soapy water.
Rinse well with fresh, clean water. Never
use chemical cleaning products on the
system's exterior surface as they may
damage the housing.
A sediment pre-filter for your system is
recommended. Sediment levels vary from
one location to another. If the flow rate
has noticably decreased, a pre-filter to
remove the sediment is usually the root
cause; or, if you have a pre-filter, once
the flow rate has noticeably decreased,
it is time to replace the filter. Allowing
sediment to continue to collect can
cause clogging and restrict the flow of
water into your home. We recommend
replacing your sediment pre-filter
cartridge every 2-3 months.
Precautions
• Do not install this filter where the
line pressure may exceed 100 psi. The
operating pressure range for this filter
is between 20psi – 100psi.
• Install on cold water lines only
(40° – 90°F). Protect unit
from freezing.
• Unit must be installed in an area
where the main water line enters your
home, before connecting to a water
heater. DO NOT install after the water
heater or on the hot water line.
• Do not install the unit on its side. It
must be installed upright to maximize
contact with media bed.
• It is recommended your system be
installed inside and out of direct
sunlight. If this is not possible and
the system is outdoors or in a
sunny area, the unit must be
protected from both direct sunlight
and freezing temperatures.
• Installation of the filter must comply
with existing state and local plumbing
codes. A. O. Smith is not liable for
consequential or incidental damages
due to improper installation.
• Improper sequence of equipment will
affect performance, and could possiby
damage your system.
NEED HELP? GIVE US A CALL 877.333.7108
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents