Table of Contents
Advertisement
Quick Links
Estimated wiring time = 15-30 minutes
Wiring Details
1210 NE Windsor Drive
Lee's Summit, MO 64086
sales@lynxspring.com
1 (877) 649-5969
JENEsys
www.lynxspring.com
Edge™ 534 – N4
®
W
I
IRING
NSTALLATION
Figure 1
G
UIDE
© 2019 Lynxspring, Inc.
All Rights Reserved
Revised 1/10/2019
JENE-EG534-N4-V1
Page 1 of 5
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Lynxspring JENEsys Edge 534 - N4
Summary of Contents for Lynxspring JENEsys Edge 534 - N4
- Page 1 ® IRING NSTALLATION UIDE Estimated wiring time = 15-30 minutes Wiring Details Figure 1 1210 NE Windsor Drive © 2019 Lynxspring, Inc. Lee’s Summit, MO 64086 All Rights Reserved sales@lynxspring.com Revised 1/10/2019 www.lynxspring.com 1 (877) 649-5969 JENE-EG534-N4-V1 Page 1 of 5...
- Page 2 Vdc or mA signal, and then wire the transmitter to the UI according to the 0–10 Vdc or 4–20 mA instructions. Figure 2 1210 NE Windsor Drive © 2019 Lynxspring, Inc. Lee’s Summit, MO 64086 All Rights Reserved sales@lynxspring.com Revised 1/10/2019 www.lynxspring.com...
- Page 3 The 15-position DO connector has common terminals marked “C” that are isolated from each other. This is useful if controlled loads are powered from different circuits. 1210 NE Windsor Drive © 2019 Lynxspring, Inc. Lee’s Summit, MO 64086 All Rights Reserved sales@lynxspring.com...
- Page 4 LED indicates activity as follows: Off–relay high-impedance/no current flow On–relay low-impedance/load current flow; relay is closed and the load is powered Figure 6 1210 NE Windsor Drive © 2019 Lynxspring, Inc. Lee’s Summit, MO 64086 All Rights Reserved sales@lynxspring.com Revised 1/10/2019 www.lynxspring.com...
- Page 5 Each type of input or output used requires a special Lynxspring Input/Output (Onyxx IO) point to be added in the station database. These components act as the station interface to the physical I/O points. The Onyxx IO points you need for each input or output type are noted in previous wiring sections in boldface.
Need help?
Do you have a question about the JENEsys Edge 534 - N4 and is the answer not in the manual?
Questions and answers